Lenovo Legion Go

Listing approved. Thanks for using Swappa.

Hi is it possible for 300?

@Fakhri S. Unfortunately no, mine is priced the lowest on the site. Recent sales were at $450-$500 for the 1TB model.

So did you set this up as a dual boot, steam and windows

@Eric H. No, was SteamOS then I swapped back to Windows for Game Pass. There are guides to do dual booting though.

How many cycles does the battery have on it?

And does this come with the original case as well

@Nate G. 64 cycles. Yes it comes with the original case. Also comes with the original charger.

Hi, is it possible for 330

Cound we agree to an offer of 400

@Eric H. Could you do $420? Just to cover the sellers fees and shipping?

@Fakhri S. Sorry, $330 is just way too low still. This is listed so far under everyone else I can't lower it much.

Im wondering if the listing is real, my birthday is coming up this Friday and I've been looking for one these since it was announced, does it have any real downsides? I am very willing to buy do to the price

@Anim O. Yes, this is very much a real posting. The other listings are about $200 over the average sale price. If you are interested then put in the purchase and I'll ship out this morning after I get off of work.

It's basically a full gaming PC in the same form factor as a switch. I ran it as my primary gaming PC (attached to an eGPU) for the whole time I've had it, I have since moved to a laptop (hooked up to that same eGPU).

Would you do 350$?

@Madan D. No. It is already priced under its average sale value. This isn't a 512GB model, nor does this have any issues.

Like the price. I would like it to be reset to the newest Windows version. Can you promise to setup before shipping to Win 11

Will it also come with the box and all accessories

@Eric H. Already reset to the newest W11 version, I'll do all of the updates as well. I don't have the original box unfortunately, but I do have the original carry case.

I never used the FPS puck on mine, but I can 3D print one for you if you would like! I can 3D print one that's like the original one or one that also doubles as a controller connector (connects the 2 together to make a single controller)

So can you do the joystick holder that makes them look like regualr controller and also the normal looking round thing to use as a mouse

@Eric H. Yes, I can print both and include them.

Hi can you make it 350? And I will buy immediately